Telephone Equipment and Service

Mounts on IX-044. Provides 4 Caller ID line circuits. Requires software V 4.71/5-71 or higher

Provides 4 caller ID line circuits and 8 ADIX digital station ports (May be used in any card slot of the IX-CMM and will not support IX-ATT)

This card contains 4 circuits for E&M TIE trunks. When this card is used, an IX-DCDCA or IX-DCDCB is also required

This card contains 4 circuits for Direct Inward Dial (DID) trunks, and requires the addition of an IX-DCDCA or IX-DCDCB. This card is used when Dial Pulse (DP) Co lines are used

This card contains 4 circuits for Direct DTMF Inward Dial (DID) trunks, and requires the addition of an IX-DCDCA or IX-DCDCB. This card includes a DTMF receiver card ([X-4RCVS) for when DTMF CO lines are used

This card contains 8 circuits for either loop start or ground start CO/PBX lines. If ground start lines are used, an optional power supply (IX-DCDCA, IX-DCDCB, or IX-DCDCM) is required

This card contains 8 circuits for caller ID CO/PBX lines. Requires software V 4.61/5.61 or higher

Supports either 24 channels or fractional Tl in increments of 8. A fractional Tl span requires the use of either 1 or 2 slots. (Requires software 4.23/5.23 or higher)

Receiver motherboard provides 8 receivers and allows the addition of up to 2 IX-8ERCV receiver modules for a total of 24 receivers. (only required when Tl circuit needs DTMF receivers)

Receiver module - provides 8 receivers and mounts on the IX-TL RCV.